Felt Overlap For Roofs

Afterward apply the felt in the same manner on the opposite side.

Felt overlap for roofs.

Once you get close to the top add another layer of felt so that you overlap the ridge of your roof by about 1 foot 0 30 m. Roofing felt is required to overlap 2 inches over the lower felt course. 15 pound roofing felt. Roll the felt so that it overhangs the edge by 2 inches.

Wrap felt over hips. Roll your felt out on the roof and cut it to fit with a utility knife. Hip roofs do not have gable ends but instead they feature sides that all slope downward and must be shingled. Work up the roof to the peak and fold felt over the top overlapping at least 3 inches and fasten it on both sides.

Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it. Therefore a 2 inch overlap provides redundancy at the edges where the barrier is weakest. Continue rolling new felt rows until you are close to the roof s peak. Do the other side of the roof the same way also with an overlap at the peak.

As you work the paper can be tacked down in the center so it won t blow away. Roofing felt or tar paper is infused with a petroleum based solution to provide an additional layer of roof protection under shingles. The overlapping felt creates a secondary barrier for moisture and wicks water away from the shingles above and the sheathing below. A hip roof may be virtually square sloping from one main roof point downward on four equal sides or it may have an extended roof ridge and additional hips designed by the architect.